From John. Ailerons have now been cut out having been built in with the main wing structure. There is a clear gap to cut to and it was a simple job. Then the open structure at cut edges is covered with 0.4 ply again straight forward. The aileron horns were cut per plan from hard… Read More »
Joe emailed me a couple of his projects, the Stampe that is ready for maiden flight ( ¼ scale) power is a 38cc four stroke petrol engine.( AUW 14.5 lbs.) The racing cyclist almost ready to race but ran out of paint. AUW 20oz. 180watts of power, should be ok.( Joe’s own design ) !!!… Read More »
I guess like most other members, I am missing the trip up to Little Haldon to get some flying in and meet up. With flying and meeting up off the agenda for a while, I decided to get my MTB out and cycle up to LH to take in the views. The steepest part of… Read More »
John continues to be busy in the workshop and has provided us another interesting update with photos. Over to you John: Still working on the wings, I did not realise just how much construction was involved, I will sometime conduct a survey on exactly how many separate items were needed to complete each wing, could… Read More »
Some more intriguing photo’s from Chris A bit more progress: The full size had a all flying tailplane, I was going to do the same, but with such a small bearing width 19mm, and a tailplane at 900mm, I couldn’t stop the tailplane wobbling, at the tip, well not enough for me. Not a problem,… Read More »
First pic is the main nose skid arrangement. This is sprung by roundels of car radiator hose as seen. The skid is a strip of flexible wood screwed down at the front and held in place at the rear by a brass strip, which is a flattened curtain fitting. The skid can move under the… Read More »
1st instalment. It all started back in 2017, when I saw a build thread on RC groups for a 1/3 scale SZD Cobra 17, the builder later posted on SSUK. Having built the ASW 17, still waiting to maiden this one, thoughts came back to the Cobra, so drew up plans for the fuz and… Read More »
Gordon’s Christmas Raffle prize, a Fun Cub XL made its debut at our March Club meeting at Kingsteignton community hall and received a lot of interest. Check it out in the Gallery
Check Out the Gallery to see the build progress made by John. A very impressive structure.
Have a look at the updated club Gallery. John has provided an update on his winter build. The Gallery now includes a jig made from 6 x 1 timber and the former supports cut to height using datum line on plan. 2nd pic shows formers positioned upright with pins before starting to glue main 6mm sqr… Read More »